PIC18F45K20-I/MV【PDF 214/234 页】MCU 32KB FLASH 1536B RAM 40-UQFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3873

210页 211页 212页 213页 [214页]215页 216页 217页 218页

dsPIC33F

DS70165E-page 78

Preliminary

2007 Microchip Technology Inc.

4.2

RTSP Operation

The dsPIC33F Flash program memory array is

organized into rows of 64 instructions or 192 bytes.

RTSP allows the user to erase a page of memory,

which consists of eight rows (512 instructions) at a

time, and to program one row or one word at a time.

Table 26-11, DC Characteristics: Program Memory

shows typical erase and programming times. The 8-

row erase pages and single row write rows are edge-

aligned, from the beginning of program memory, on

boundaries of 1536 bytes and 192 bytes, respectively.

The program memory implements holding buffers that

can contain 64 instructions of programming data. Prior

to the actual programming operation, the write data

must be loaded into the buffers in sequential order. The

instruction words loaded must always be from a group

of 64 boundary.

The basic sequence for RTSP programming is to set up

a Table Pointer, then do a series of TBLWT instructions

to load the buffers. Programming is performed by set-

ting the control bits in the NVMCON register. A total of

64 TBLWTL and TBLWTH instructions are required to

load the instructions.

All of the table write operations are single-word writes

(two instruction cycles) because only the buffers are

written.

programming

cycle

required

for

programming each row.

4.3

Control Registers

There are two SFRs used to read and write the

program Flash memory: NVMCON and NVMKEY.

The NVMCON register (Register 4-1) controls which

blocks are to be erased, which memory type is to be

programmed and the start of the programming cycle.

NVMKEY is a write-only register that is used for write

protection. To start a programming or erase sequence,

the user must consecutively write 55h and AAh to the

NVMKEY register. Refer to Section 4.4 “Programming

Operations” for further details.

4.4

Programming Operations

A complete programming sequence is necessary for

programming or erasing the internal Flash in RTSP

mode. A programming operation is nominally 4 ms in

duration and the processor stalls (waits) until the oper-

ation is finished. Setting the WR bit (NVMCON<15>)

starts the operation, and the WR bit is automatically

cleared when the operation is finished.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式